SPURS - Ordering
MEASUREMENTS NEEDED FOR ORDERING AND INSTALLATION
A Measure shaft diameter (A) to determine cutter models available for your shaft.
B Measure propeller hub diameter (B) and match this to closest possible cutter hub diameter (this will determine exactly which model you will require.
C Measure space (C) between propeller and stern bearing housing. Compare space with minimum space for installation on dimension chart – if below minimum see spacer selection chart (below).
D Measure stern bearing housing diameter (D). This is required in order for us to determine wedge holding block height.
Quotation Form
![spurs measurements](https://www.haroldhayles.co.uk/wp-content/uploads/2022/09/spurs-measurements.jpg)
Product guide table
![Screenshot 2022-09-01 at 16.40.30](https://www.haroldhayles.co.uk/wp-content/uploads/2022/09/Screenshot-2022-09-01-at-16.40.30.png)
![86prod1](https://www.haroldhayles.co.uk/wp-content/uploads/2022/09/86prod1.gif)
![86prod2](https://www.haroldhayles.co.uk/wp-content/uploads/2022/09/86prod2.gif)
![86prod3](https://www.haroldhayles.co.uk/wp-content/uploads/2022/09/86prod3.gif)